Spectrum-controls 1756sc-IF8u Uživatelský manuál stáhnout pdf (Strana 21)

Installing And Wiring Your Module

Read this chapter to install and wire your module. This chapter covers:

• avoiding electrostatic damage

• determining power requirements

• installing the module

• wiring signal cables to the module’s terminal block

Electrostatic

Damage

Electrostatic discharge can damage semiconductor devices inside this

module if you touch backplane connector pins. Guard against electrostatic

damage by observing the following precautions:

CAUTION

ELECTROSTATICALLY SENSITIVE COMPONENTS

• Before handling the module, touch a grounded

object to rid yourself of electrostatic charge.

• When handling the module, wear an approved wrist strap

grounding device.

• Handle the module from the front, away from the

backplane connector. Do not touch backplane connector pins.

• Keep the module in its static-shield container when not in

use or during shipment.

Failure to observe these precautions can degrade the

module’s performance or cause permanent damage.

Chapter 2

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 117 118

Žádné komentáře

Spectrum-controls 1756sc-IF8u Uživatelský manuál Strana 21