Spectrum-controls 140 MPM 204 00sc Uživatelský manuál stáhnout pdf (Strana 22)

Quantum Series 140 MPM 204 00sc

3.3.

3. At the module end of the cable, cut the drain wire and foil shield.

4.4.

4. Check the signal wires to ensure that they are the correct length to connect to the terminal block.

5.5.

5. At the input device end of the cable, twist the drain wire and foil shield together. Under normal

circumstances, you will connect the drain wire and shield to earth ground, via a panel or DIN rail

mounting screw at the end of the module. Keep the length of the drain wire as short as possible.

6.6.

6. Connect the cable to the input device as required.

7.7.

7. Repeat steps 1 through 6 for the other cables.

8.8.

8. Configure the module as described in chapter 3, “Module Configuration.”

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 65 66

Žádné komentáře

Spectrum-controls 140 MPM 204 00sc Uživatelský manuál Strana 22